Quality Laminate Countertops

Mal-O-Sen Co., Inc.

Durable Elegance

Image of 5 company logos: Formica, Greenlam, Nevamar, Pionite and WilsonArt brand plastic laminate

Measuring Existing Cabinets

Make an outline sketch of what the countertops look like (fig.1).

If the countertops fit well and no adjustments are needed proceed as follows; Using a good quality steel tape measure, make sure the tip is 90° to the blade (not bent). Take measurements along the wall of all the existing countertops.

Measure existing island countertop length from end to end of island. Measure across island to determine width. If a countertop butts into a wall put end of tape up against wall and take measurement on exposed end.

If measuring between walls place end of tape in right corner with tip touching wall, measure out 24" and put pencil mark on wall (fig. 2), then put end of tape in left corner with tip touching wall and measure to pencil line (fig. 3), write down this measurement and add 24" (example 114-3/4" + 24" = 138-3/4").

As you get measurements write them down on the sketch you drew previously.

Also make note of ends that get finished (capped) or may need a radius, etc.

You also may need front cabinet measurements. This would apply to diagonal corner cabinets, angle-end base cabinets, etc. Sometimes countertops with odd angles or nonstandard widths may need a template made before the countertop can be manufactured and cut.

Typical Countertop Overhang

Click on images to enlarge.

Image of a cabinet drawing as if looking down from above Fig. 1

Image of a tape measure showing 24 inches. Fig. 2

Photo of a tape measure showing 114 3/4 inches Fig. 3